ã€China Aluminum Industry Network】1. Discoloration and Decolorization of Aluminum Plastic Panels:
Discoloration and decolorization of aluminum-plastic plates are mainly caused by improper selection of plates. Aluminium-plastic panels are divided into indoor panels and outdoor panels. The surface coatings of the two panels are different, which determines their applicable different occasions. The plates used in the interior are usually coated with a resin coating. This coating cannot adapt to the harsh outdoor environment. If it is used outdoors, it will naturally accelerate its aging process and cause discoloration and discoloration. The surface coating of outdoor aluminum-plastic composite panels is generally made of a fluorocarbon resin coating with strong anti-aging and anti-ultraviolet resistance. This type of panel is expensive. Some construction units deceived the owners to impersonate anti-aging and anti-corrosion high-quality fluorocarbon plates with indoor plates, and squeezed unreasonable profits. As a result, the aluminum plates used in the project were seriously discolored and discolored.
2, aluminum plastic plate open plastic, off:
The opening and detachment of aluminum plastic panels is mainly due to improper selection of adhesives. As the ideal adhesive for outdoor aluminum-plastic board project, silicone rubber has unique advantages. In the past, China's silicone rubber relied heavily on imports. Its price was deterred by many people, and only those curtain wall projects that were expensive on high-rise buildings were dare to pay attention. Now, China's Zhengzhou, Guangdong, Hangzhou and other places have put into operation different brands of silicone rubber, resulting in a sharp drop in prices. Now, when buying aluminum plastic board, the seller will recommend that kind of special quick-drying glue. This glue can be used indoors and used in the outdoor where climate change is unpredictable.
3, aluminum plastic plate surface deformation, from the drum:
There are many reasons for the surface deformation and drumming of aluminum-plastic panels. Previously in the construction, there have been such quality problems, we once thought that the quality of the plate itself; later, after a concentrated analysis of everyone found that the main problem lies in the paste of aluminum plastic plate on the substrate, followed by aluminum plastic The quality of the board itself. Dealers often provide us with the construction process of aluminum-plastic panels. The basic materials that we recommend to use are mainly high-density boards, wood boards, and the like. In fact, when these materials are used outdoors, their service life is very fragile. After being blown by the wind, sun, and rain, they will inevitably undergo deformation. Since the grass-roots materials are all deformed, why does the aluminum-plastic board as a surface layer not deform? It can be seen that the ideal outdoor base material should be rust-proofed and angle steel and square steel pipes should be used as the skeleton. If conditions permit, the use of aluminum profiles as skeletons is even more desirable.
The cost of the skeleton made of such metal materials is not much higher than that of wood keel and high density plates, which can really guarantee the quality of the project.
4, aluminum plastic plate glue neatly:
When the aluminum-plastic panel is used to decorate the surface of a building, generally there is a gap of a certain width between the panels. For aesthetic needs, black sealants are generally filled in the gaps. In order to save time, some construction workers do not use paper tape to ensure the orderliness and rules of plastic injection. Instead, they use the protective film on the surface of the aluminum plastic panel as a substitute. As the aluminum-plastic board cuts, the protective film will produce different degrees of tearing, so use it as a substitute for the protective tape, it is impossible to neatly gather the glue.