Conductive oil pump assembly process needs to be carried out gradually according to process requirements, to eliminate barbaric operations, a direct impact on the quality of heat-conducting oil pump products. Specific steps are as follows: First, to the parts warehouse to receive the assembly of heat pumps need all the necessary accessories. Second, the heating cleaning machine, all the thermal oil pump impeller, thermal oil pump bearing sleeve, thermal oil pump body, pump cover, gland, shaft cleaning. Third, remove the heat pump accessories from the cleaning machine to clean the cotton yarn in sequence, placed on the pump loading station, ready for assembly. Fourth, the pump coupling mounted on the shaft section of the pump shaft of the heat transfer oil pump. Fifth, the first heat-conducting oil pump shaft off the first seal into the heat-conducting oil pump gland, and from the other end of the pump shaft mounted on the pump shaft. Sixth, the card spring along the spindle lock sleeve sleeve on the pump shaft and the card spring stuck in the gland after the first card spring slot, and then the first piece of bearing grease mounted on the bearing of the heat transfer oil pump Body, row bearing bearing position must be and the bearing body position is square, with copper rods will be placed next to the pump bearing the first bearing body bearing bit. Do not force too hard, so as not to damage the bearings. Seventh, the spindle from the bearing penetrate the interior mounted on the bearing body, the gland tighten the bearing body. Eighth, the bearing body from the other end of the spindle into the second bearing, the same way with the sixth. Ninth, the retainer along the shaft into the card and stuck in the card next to the retainer groove, adding a ring. Tenth, prepare the oil-immersed heat-conducting oil pump high-temperature carbon fiber packing sealed in advance into the bearing body and take the casing to compact it. Eleventh, the heat-conducting oil pump body mounted on the pump bearing body, the heat-conducting oil pump high temperature skeleton oil seal along the shaft into the heat-conducting oil pump cover, and a good pressure ring and lock the mother. Twelfth, the thermal pump impeller mounted, and lock the lock mother. Thirteenth, the high-temperature heat-conducting oil pump pump seal aluminum gasket into the pump body, the heat pump pump cover bearing bearing body stand upright and tighten the bolts. Fourteenth, the entire heat transfer oil pump assembly is completed.
Single Curtain Track,Straight Curtain Track,Pvc Straight Curtain Track
Botai Window Decoration Material Co., Ltd. , http://www.wlcurtainrod.com