The new concentrated cooling ring, supplemented by the REGO-FIX tool holding system, delivers the cooling lubricant to the cutting edge. This allows for better chip discharge and longer tool life. In addition, it saves the cost of expensive cutting-edge tools required for certain cutting applications.
The ER tool clamping system is a simple and easy-to-use multi-tool holder that provides reliable and good results. According to the introduction of REGO-FIX, its accuracy is higher than the requirements of the DIN standard. The system consists mainly of a shank, a collet, a nut, a seal and a tool. Among them, the sealing ring is used for tools with internal coolant passages. The sealing ring is placed on the nut, thereby achieving a sealing effect on the front end of the tool. O-rings ensure 100% functionality of the system when using corrosive cooling lubricants (KSS). In addition, chips and dirt do not enter the slots of the collet chuck. A cooling lubricant with a maximum pressure of 1.5 x 107 Pa is introduced into the tool through the coolant passage while the seal remains sealed. Therefore, the cooling lubricant can be directed into the cutting area of ​​the cutting edge.
The new CoolantFlushDisk concentrated cooling ring with a diameter of 3~20mm is like a conventional sealing ring, but it has no O-ring and is therefore not sealed. The cooling lubricant is introduced forward along the tool through the guide channel and reaches the cutting area accurately. According to REGO-FIX, the centralized cooling ring is actually a logical development in the seal. Depending on the application, the user can choose a suitable system. This concentrated cooling ring has significant advantages over externally cooled lubricant delivery systems. The new technology of concentrated cooling rings maximizes coolant efficiency and allows for the rapid removal of chips and extended tool life. In addition, depending on the location of use, the tool can also be free of cooling slots. Centralized cooling rings are available for all types of REGO-FIX collets and nuts, and can be quickly replaced and matched to different tool diameters.
Concerned about surprises
Tag: Cooling Lubricant Tool Chips O-ring CoolantFlushDisk
Previous: Three characteristics of power tools and nine application areas Next: Eight major considerations need to keep in mind when using tools
Temperature Sensor,Thermocouple Thermometer,Temperature Monitor,Temperature Instruments
Wuxi Winsun Automation Instrument Co., Ltd , https://www.jswxwinsun.com