What are the reasons for the insensitivity and short distance of the LeCurry RK315DT outdoor detector?

The RK315DT is a versatile detector with a mounting height of 1-2.7 meters, a range of 90 degrees X 15 meters (default lens), and a pet-proof, channel-type, barrier-type lens. Slide the PCB in the inner seat to the corresponding position according to the height table (1m, 1.5m, 2.2m, 2.7m) printed on the bottom left corner of the PCB. The green light represents the microwave, the yellow light represents the passive infrared, and the red light represents the alarm. If the green light is off and the yellow light is off, the detector will not alarm. The reason is that the passive infrared does not detect the alarm signal. It must be solved by adjusting the sensitivity of the passive infrared. If the yellow light is off, the detector will not alarm. The reason is that the microwave The alarm signal is not detected and must be solved by adjusting the microwave sensitivity.

Light Emitting Diode Lamp Beads

Like ordinary diodes, light-emitting diodes are composed of a PN junction, and they also have unidirectional conductivity. When a forward voltage is applied to the light-emitting diode, the holes injected from the P area to the N area and the electrons injected from the N area to the P area are respectively in contact with the electrons in the N area and the voids in the P area within a few microns of the PN junction. The holes recombine and produce spontaneous emission fluorescence. The energy states of electrons and holes in different semiconductor materials are different. When electrons and holes recombine, the energy released is somewhat different. The more energy released, the shorter the wavelength of the emitted light. Commonly used are diodes that emit red, green or yellow light. The reverse breakdown voltage of the light-emitting diode is greater than 5 volts. Its forward volt-ampere characteristic curve is very steep, and it must be used in series with a current-limiting resistor to control the current through the diode.
The core part of the light-emitting diode is a wafer composed of a P-type semiconductor and an N-type semiconductor. There is a transition layer between the P-type semiconductor and the N-type semiconductor, which is called a PN junction. In the PN junction of certain semiconductor materials, when the injected minority carriers and the majority carriers recombine, the excess energy is released in the form of light, thereby directly converting electrical energy into light energy. With reverse voltage applied to the PN junction, it is difficult to inject minority carriers, so it does not emit light. When it is in a positive working state (that is, a positive voltage is applied to both ends), when the current flows from the LED anode to the cathode, the semiconductor crystal emits light of different colors from ultraviolet to infrared, and the intensity of the light is related to the current.

Emitting Diode Lamp Beads,Led Blue Hair Blue,3030 Lamp Beads,In Line Led Blue

Dongguan XINYUDA Technology Co., Ltd. , https://www.gdxige.com

This entry was posted in on