In recent years, the floor has been loved by the owners. Whether it is the environmental protection of the floor or the characteristics of the plants, it has brought us a healthy home life. However, there are often a series of problems on the floor, which always leave us unprepared. What is the reason? What do you say with an expert?
Generally, there are more phenomena in use when the floor is tiled or arched. This is mainly due to the dampness of the floor. The reasons for the dampness of the floor are as follows:
1. Moisture in the air (eg Huang Meitian);
2. The floor did not dry out, reinforce the keel with cement;
3, keel, wool floor is too wet, the use of water-based glue;
4. No moisture treatment is performed on the damp environment such as the first floor;
5. The section of the junction between the stone floor and the floor is not closed.
7, blisters (such as broken water pipes, balcony water intrusion, etc.).
In addition, the product itself and improper construction can cause arching. For example, improper drying, insufficient health, low moisture content, too shallow back groove, insufficient expansion gap during construction, and too tight laying. Many informal factories now use some inferior quality, dry-in-place sheets. After additive coloring, retouching impersonation of first-class boards and pitting consumers, this is one of the main reasons leading to floor deformation. Due to working hours in solid wood flooring, the surface is painted six times and the floor bottom is painted once. The upper and lower stresses are inconsistent. Outside air affects the floor and causes deformation.
Indoor heating and heating, the interior is very dry, which is equivalent to the second drying of all wood products at home, solid wood products are natural plants, it will inevitably produce changes. This is to require the use of attention should be paid to the indoor control of dry humidity and dry humidity control. This is also good for the human body. Some people say that solid wood flooring is so easy to change, then it will not spread solid wood! This is not true. It is because of the changes in solid wood floors that the advantages of natural plants are reflected. Natural environment protection, absorbing gases harmful to the human body, and distributing substances that are beneficial to the human body. It requires us to overcome the disadvantages of easy deformation of the floor as much as possible during floor processing.
Industry sources said: It's hard to avoid dampness
At present, it is difficult to avoid dampness in major cities, especially in the spring. Therefore, consumers should ask the floor paving company to confirm whether there is any damp source in the paving shop before the paving. (The indoor wet source may not be completely dry for the new house floor cement, the water vapor leakage of the cement layer under the new paving tile for the bathroom and the kitchen, balcony External door and indoor partition or exterior wall seepage, villa groundwater vapor intrusion and pre-drainage pipe, air conditioning pipe, water leakage pipe, etc.) and take corresponding and effective measures to isolate water vapor intrusion, isolation of key parts are kitchen, bathroom, open-air balcony At the junction with the room with paved floors, waterproof insulation must be used for waterproofing.
After the pavement is installed, it is still necessary to pay attention to window ventilation, especially the rooms on the ground floor and east windows. National and industry standards have stipulated that the humidity of the air should reach 70% or more, and measures must be taken to prevent possible water vapor damage. The floor is a natural material product, and it is normal for it to produce a little gap, warping, and discoloration during use. A small amount of floor noise, cracks or lacquer cracks, cracking is also difficult to completely avoid.
According to the national standard, the pavement must be inspected within three days after the pavement is installed. The owner is advised to retain a packet of intact flooring samples. In this case, if there is a problem after the inspection, please check with the quality supervision department to be able to distinguish whether the quality of the flooring or the quality of the pavement has been resolved. Paved floors cannot identify their own quality problems.
From the perspective of responsibility and responsibility, the moisture isolation project should be implemented by the interior decoration company. If the floor is also paved by the interior decoration company, the responsibility for problems in the future is very clear. However, if the floor is responsible for the pavement, then the factory should confirm that the indoor moisture isolation is done before the pavement, and vice versa should also be reminded, it is best to confirm in writing. Otherwise, if there is a dispute, the responsibility will be difficult to distinguish, and ultimately it will be the victim of the consumer.
Different responsible parties are responsible for product quality, construction quality and quality of finished product maintenance. But there must be a reminder here that wood flooring has quality problems, sometimes it does not appear at one of the stages, and it often occurs during use. This will confuse the product quality, paving quality, and maintenance quality of the flooring. After-sales service personnel must be calm and calm, observe the test carefully, and make judgments with caution.
Building materials knowledge del floor nature floor paint window cement home room floor tile villa door villa exterior wall brick villa door and window bathroom waterproof toilet waterproof material bathroom door bathroom floor tile bathroom leaking water villa figure decoration home
Trail Marking Tape,Blue Trail Marking Tape,Red Trail Marking Tape
Fenghua Jade Motor Co., Ltd. , http://www.flagtapes.com