High-flow heat-conducting oil pump seal features: (i), the large flow heat-conducting oil pump is based on the digestion and absorption of foreign oil pump developed the second generation of products, the basic structure of single-stage single-suction cantilever foot support structure, hot oil pump imports for the axial Inhalation, the outlet is centered vertically upward, and the motor is mounted on the base. (Ii), high-flow heat-conducting oil pump support the use of double-ended ball bearing structure, the front end is lubricated with grease, the rear end is lubricated with oil, the middle of a guide tubing, to observe the sealing and recovery of thermal oil. (Iii) The high-flow heat-conducting oil pump adopts a self-heating and heat-dissipating structure, which changes the traditional water-cooling structure and makes the structure simple, small in size, and saves operation cost, and has good performance and reliable use. (Iv) high flux heat pump with a combination of packing seal and mechanical seal, packing seal with high temperature filler, with good thermal adaptability, and mechanical seal is the use of high mechanical strength, good wear resistance of cemented carbide Materials, to ensure the sealing performance under high temperature conditions. ㈤, high-flow heat-conducting oil pump uses the third generation of polytetrafluoroethylene (PTFE for short) to make the lip seal, so that the sealing performance has taken a leap forward. Compared with the rubber type, the sealing reliability is improved by 25 times and the corrosion resistance is extremely strong.
Car Elevator,Auto Elevator,Automobile Elevator,Car Lift Elevator
Homefriend&FUJI Elevator Co.,Ltd , https://www.jfujilift.com