The maintenance steps for the scraper ring are as follows:
First, check whether the contact area of ​​the brush and the slide is within the specified range. When working, we must ensure that the brushes are in contact with the slide. If there is a deviation between the top and bottom, the relevant brush holder position should be adjusted.
Second, what is needed is to check the wear of the brush block. If the density of the brush block is not good, then it should be replaced.
Third, the need to check is whether the slide is smooth, if it shows dust and the like, we must also pay attention to the timely removal, as well as smoothing the surface, processing.
Fourth, it is necessary to check the brush holder, and whether there is a situation where the connection is not in contact with the connection, or a burn, if it is, it must be replaced in time.
Concerned about surprises
Label: How to maintain the collector ring of the scraper
Previous: Composition of plastic bellows equipment Next: Common faults of air compressor
Hollow Polycarboante Sheet,4Mm Polycarbonate Sheet,Amti Uv Pc Sheet 4Mm,Anti-Fog Polycarbonate Sheet
ZHENHAO BUILDING MATERIALS CO.,LTD , https://www.zhpvctile.com