Hot melt glue guns are used in many times. There are many kinds of nozzles designed in production so that they can meet different production line requirements. Today we will talk with you about the knowledge of hot melt glue guns . After watching, I hope to help friends in need.
Hot melt glue gun use method
1. Before using the hot melt glue gun, please check whether the power is on or not, and whether the bracket is ready; whether the glue gun used has been used smoothly.
2. When using the hot melt glue gun, insert the power cord and warm it up for about 5 minutes or until the tape is completely melted. When the applicator is not in use, stand upright on the desktop.
3. Wait until the glue stick melts. Align the glue gun nozzle with the part that needs to be glued. Press the trigger slightly to allow the glue to flow naturally.
4. After using the nozzle down, unplug the power plug.
5. Never pull the tape out of the inlet.
6. Since the temperature of the hot melt glue gun is extremely high during use, never touch the gun mouth or the glue at hand.
The reason why the hot melt glue gun can't make glue
If no glue is found during the use of the glue gun, it is necessary to check whether the glue gun is hot. If the heat cannot be normal, it may be that the glue gun power supply is not inserted or the glue gun is burned out due to a short circuit. If the applicator can heat normally, there are two possible causes for the fuser to fail to release the glue.
1. The gun mouth is blocked by the impurities and should be handled by professionals.
2. The glue gun pours glue to make the strip thicker. At this point, it is only necessary to gently rotate the strip one time and carefully pull back a small part of it to strip off the thickened part of the strip and continue to use it.
Hot melt glue gun precautions
1. Avoid using the sol gun in a humid environment. Humidity can affect the insulation performance and may cause electric shock.
2. Nozzles and adhesives are very hot (approximately 200 degrees). Do not touch other parts except the handle.
3. Never pull the strip from the glue inlet. Hot melt can cause serious burns or damage the glue gun.
4. Do not disassemble and install the parts of the heater or heater at will, otherwise it will cause malfunction.
5. Do not let children touch and store outside of contact.
6. Do not use anything other than melt.
7. If there is a backflow phenomenon in the glue gun in the glue gun, stop using it immediately and wait for the professional to clean the back flow of hot melt adhesive before use.
8. The glue gun is heated continuously for more than 15 minutes. Please cut off the power.
The above is how to use the hot melt glue gun and related introductions. After reading it, we will have more understanding of this aspect. We hope the above introduction can help everyone. If you want to learn more, please continue Concerned about this site, more exciting so stay tuned!
Professional Moving Head Lights,Dj Moving Head Lights,Led Moving Head Light,Beam Moving Head Light
Big Dipper Laser Science And Technology Co., Ltd , https://www.bigdipper-laser.com