Precautions when using wire trimming function in EDM wire cutting machine tools Wire EDM cutting in EDM has increased the tool trimming function compared to EDM wire cutting. Used for cutting, the next few knives are used for finishing, so the use of EDM wire cutting machine can achieve a higher finish.
Because the electrode wire used in the wire-cutting machine tool in EDM is used repeatedly. When the knife repair function is used, as the cutting area increases, the electrode wire generates wire drawing and electrode wire loss, which will become thinner and thinner, which ultimately affects the accuracy of the work and the effect of the next few discharge cutting.
In order to obtain high accuracy, it is necessary to measure the actual diameter of the molybdenum wire before starting to cut. It is recommended to tighten the molybdenum wire after cutting the guide wire and before officially cutting the workpiece. If the molybdenum wire has been used repeatedly for a long period of time, the diameter and roundness of the molybdenum wire need to be measured. If the difference is too large, a new electrode wire must be replaced.
Pay attention to the following points when using multiple cuts:
1. When the molybdenum wire runs empty, check whether the molybdenum wire shakes.
2. Whether there are cutting marks on the surface of the conductive block, and whether the molybdenum wire is trapped in the conductive block.
3. Whether the working fluid flow and color are normal.
4. Before processing, the process needs to be simulated. Determine whether the cutting program generated by the system is true.
5. According to the characteristics of the material, the working cut-off amount of the last cut is as long as possible to reduce the influence of material deformation.
6. Several problems on the working surface after cutting:
â‘ Line marks on the surface may be caused by jitter of the electrode wire or deformation of the material and unreasonable setting of the offset.
â‘¡The black spots on both ends of the working surface are serious, and the working fluid is a problem. It is recommended that you can try to use water-based cutting fluid.
â‘¢After cutting, please clean with oxalic acid in time, then rinse with water to remove oxalic acid residue. Wipe off the water stain with a clean white cloth, and finally apply anti-rust oil.
Suzhou Serge Electronic Technology Co., Ltd. provides multi-axis CNC electric spark small hole machine, multi-axis CNC electric spark micro hole machine, high-speed electric spark perforator, ECM electrolytic deburring, ECM electrochemical deburring machine, EDM take off tap Machine, CNC EDM wire cutting machine, EDM machine tool technical service, the company can tailor various EDM special machines according to the special requirements of customers, and can provide customers with a complete set of EDM solutions.
================================================== ================================================== ======
Suzhou Shuerjie Electromechanical Technology Co., Ltd. Website
Dongguan HengTaichang Doors Co, Ltd. , https://www.dghtcdoors.com