1. Remove the pipe plug from the ground drain. After checking that there is no debris in the pipe, clean the pipe around.
2. The floor on which the toilet is installed must be hard and flat. Can not be covered with floor tiles or other decorative materials, sand and debris should be cleaned up.
3. Before the toilet is fixed. To make it level and calibrate with a level.
4. There are two options for fixing the toilet:
(1) Pulling bolt fixing method: Place the toilet in the installation position, draw the contour of the toilet foot on the ground, and draw the bolt hole position through the mounting hole on the toilet. After punching the hole, insert the explosion bolt, apply the adhesive at the junction of the toilet discharge port and the ground drain outlet, place the toilet seat smoothly, firmly pull the bolt, and finally seal the toilet foot with cement mortar.
(2) Cement bonding method: draw the bottom line of the toilet bowl on the ground, and lay a circle of cement mortar with a width of 30mm and a height of 15mm along the outline, and put it on the junction of the toilet discharge port and the ground drain outlet. Adhesive, wipe the bottom of the toilet bowl, place it firmly in the installation position, make it bond firmly, and wipe off the overflowing cement mortar.
5. The cement slurry and the stubble cement adhered during the construction shall be removed before drying, so as not to be removed after drying.
6. Connect the inlet pipe and make sure it does not leak.
7. Test the flushing several times after about one hour to ensure the smooth discharge of the sewage pipe. Test the sewage discharge effect by installing the accessories in the water tank, filling it with water, putting a piece of toilet paper in the toilet bowl and dropping a drop of ink, leaving no trace at one discharge, indicating that the water is unobstructed.
8. The toilet should not be used within three days after installation, so as not to affect its stability.
9. If the toilet is not broken as described above, the responsibility is to be rented by the installer.
Read the instructions carefully before installing the toilet and follow the instructions. The "Code for Construction of Residential Decoration Projects" stipulates that the connection between sanitary ware and inlet pipe and sewage outlet must be strict, and there must be no leakage. The toilet is fixedly installed with expansion bolts, and sealed with oil lime or silicone glue. The base should not be used. Cement mortar is fixed. This not only avoids the cracks in the toilet caused by the cracking of the cement, but also facilitates the maintenance in case of problems in the future.
Wall Ornament,Solar Light,Solor Light Wall Decoration
wall ornament garden decoration Co., Ltd. , http://www.gardendecorat.com