The speed of the first and third screw pumps is selected
The flow rate of the three-screw pump is linear with the speed. Compared with the low-speed screw pump, the high-speed screw pump can increase the flow rate and lift, but the power is obviously increased. The high speed accelerates the wear between the rotor and the stator. The screw pump is prematurely disabled, and the high-speed screw pump has a short stator length and is extremely wearable, thereby shortening the service life of the screw pump.
The speed is reduced by the reducer or the stepless speed regulation mechanism, so that the surveying speed is kept within a reasonable range of less than three hundred revolutions per minute, and the service life can be extended several times compared with the high speed running screw pump.
Second, the quality of the screw pump
At present, there are many kinds of screw pumps on the market. Relatively speaking, the imported screw pump has reasonable design and excellent materials, but the price is high, the service is not in place, the price of accessories is high, and the order period is long, which may affect the normal production. run. Most of the domestically produced products are imitation imported products, and the quality of the products is mixed. When selecting domestically produced products, when considering the cost performance, the products with low speed, long lead, good transmission parts and long service life are selected.
Third, to ensure that debris does not enter the pump body
The solid impurities mixed in the wet sludge will cause damage to the rubber material stator of the screw pump, so it is very important to ensure that the debris does not enter the pump cavity. Many sewage plants install the pulverizer in front of the pump, and some installations are also installed. The grille device or the filter screen blocks the debris from entering the screw pump, and the grille should be cleaned in time to avoid blockage.
Fourth, maintain a constant outlet pressure Screw pump is a volumetric rotary pump, when the outlet end is blocked, the pressure will gradually increase, so that the predetermined pressure value is exceeded. At this time, the motor load increases sharply. The load of the transmission machinery related parts It will also exceed the design value. In severe cases, the motor will burn out and the transmission parts will break. In order to avoid damage to the screw pump, a bypass relief valve is usually installed at the outlet of the three-screw pump to stabilize the outlet pressure and keep the pump running normally.
Fifth, avoid breaking materials
The three-screw pump is never allowed to operate under the condition of breaking the material. Once it happens, the rubber stator burns due to dry friction and instantaneously generates high temperature. Therefore, the pulverizer is intact and the grille is unblocked, which is one of the necessary conditions for the normal operation of the screw pump. To this end, some screw pumps also have a shut-off device installed on the pump body. When the material is broken, due to the self-priming function of the screw pump, a vacuum will be generated in the cavity, and the vacuum device will stop the screw pump.
Concerned about surprises
Label: Working Notes for Three Screw Pumps
Previous: How to use KOYO bearings for maintenance and lubrication Next: The key to extending the service life of 7 heat transfer oil furnaces
Cosmetic Bags,Travel Cosmetic Bag,Women'S Cosmetic Bag,Simple Travel Cosmetic Bag
Dongguan C.Y. RedApple Industrial Limited , https://www.redapplebags.com