Driver current is high for the following reasons: 1, the relative density of process media and viscosity beyond the target. Approach: Check the material components to the viscosity and relative density and design value is consistent, by the process operator to adjust. 2, electrical failure. Approach: Check the circuit breaker heater setting, check the voltage, the three-phase current should be balanced, the error is not more than 3%. 3, When the pump starts, the outlet valve is fully open and the resistance inside the outlet pipe is too small. Approach: The outlet valve is closed, the pump starts slowly open the outlet valve. 4, balance pipe is not smooth, approach: clear balance pipe. 5, the pump assembly is not good, the static part of the friction or stuck. Approach: re-assembly of the pump, check with the clearance, bearing clearance, mechanical seal positioning, and strictly in accordance with the design requirements to be adjusted.
General Purpose Drywall Anchors
Sharp Drywall Anchors,Hollow Brick Expansion Bolt,Special Expansion Bolt,Brick Expansion Bolt
Kunshan Zhonggu Precision Hardware Co., Ltd. , https://www.zgfastener.com