Core Tip: The cylinder, the hydraulic cylinder, is a linear motion actuator with an output force proportional to the effective area of ​​the piston and the differential pressure across the two sides. Its function is to convert hydraulic energy into mechanical energy.
Here are some tips for using the cylinder:
Installation and operation
Unpacking
The cylinder is sealed with a vaporized rust inhibitor, so the plug of the inlet must not be removed before assembly. If the plug is removed, it must be installed on the body immediately and filled with oil in the cylinder.
Rust prevention
After the cylinder is mounted on the body, if the piston is placed under the extension, grease must be applied to the exposed portion of the piston rod.
speed
For normal-sized cylinders, when the operating speed exceeds 2m/s, the service life will be affected. In the case of 0.3m/s as the end of the stroke, it is recommended to install the buffer mechanism internally for the purpose of protection of the mechanism and safety. In addition, when the cylinder is stopped, in order to protect the cylinder mechanism and safety, the line must also be considered to prevent a large impact. In order to increase the oil return of the cylinder, special attention should be paid to the design of the circuit. When operating at a low speed of 0.5 m/min or less, the operation (especially vibration) will be affected. Therefore, when running at low speed, it should be negotiated.
Running
At the beginning of the operation, the air in the cylinder must be completely drained. In the case of residual air, take full operation at low speed to remove air. If the residual air in the cylinder is subjected to rapid clamping, the seal may be burnt due to the action of the hydraulic oil. In addition, if a negative pressure is generated inside the cylinder during the operation, an abnormality may occur due to cavitation.
Concerned about surprises
Label: Precautions for using the cylinder
Previous: Performance and introduction of quenching oil Next: 26 kinds of ceramic toilet products failed sampling
Carbide Bar For Vsi Crusher,Round Carbide Bar,Vsi Rotor Carbide Strips,Cemented Carbide Flat Bars
Zhuzhou Kerui Cemented Carbide Co., Ltd. , https://www.carbide-china.com