The wall is also a very important renovation project, and the wall is also the decoration of the "face" Oh, so the process must be aware of the interior brushing the wall, so that you can better take care of your face. With the small series below to see what is the process of the interior brush wall.
Interior wall brushing process
Interior wall brushing process
First, remove the dust from the original wall and wipe it with a duster or a dry rag. If there is a peeling place on the wall, you must use a putty knife to clean it. The peeled area must be clean, otherwise the brushed wall will not be even. Need to repair the place to putty, but also to fight sandpaper.
Interior brush wall process II
After clearing the wall, the next step is to dilute the paint. Mix the brand latex paint with 10%-15% water.
Interior brush wall process III
The following will begin to brush the wall.
Indoor brush wall considerations
1. The general rule of brushing is from left to right, from top to bottom, first inside and outside, before it is easy to be easy.
2. The speed of the paint brush should be the same as the speed, and the force should be even to ensure the uniform coating.
3. When brushing, do not brush too many times to prevent blistering or brush marks.
4. When the brush is on the top, the oil must be reduced and the action should be quick. Brush it several times to prevent sagging.
5. The construction site should be properly ventilated.
6. At the end of brushing or middle rest, the brush should be soaked in solvent or washed and dried.
Editor's summary: The indoor brushing process is introduced here. For more information, you can follow this site information.
Wall construction wall paint
Industrial sectional doors are the most durable and longest lasting doors to ensure circulation at the areas of the factory entrance and exit of goods, loading and unloading areas.
The body of sectional door is forming by 40 mm sandwich panels. These panels provides sound and heat insulation due to the intense doped polyurethane insulation was injected between galvanized steel sheet. (50 kg/m3).
Industrial sectional door systems provide space-saving with opening parallel to the ceiling.Any opening can be used clearly . and produces in accordance with the transition range and the height in the factory buildings or warehouses.
Doors is working sliding by be the most appropriate the gap between the top level of the gate with a ceiling height within the side rasils. The door can be mounted in different ways according to the gap distance (standard, low, highlift and vertical track systems).
Industrial sectional doors can easily be opened automaticly by 230-380 V-AC/50 Hz electric motor or manualy thanks to torsion spring system that balances the weight of the door.The galvanized springs are made to be durable of 25.000 door cycles.Motor with emergency chain All the drive systems have a mechanical back-up system fitted to the reduction gearbox of the electric motor, so that the sectional door can be opened if the power fails. The reduction gearbox can then be powered using the chain.
Industrial Sectional Door,Industrial Overhead Sectional Door,Industrial Warehouse Sectional Door,Industrial Garage Interior Sectional Door
Shenzhen Hongfa Automatic Door Co., Ltd. , https://www.highspeedshutterdoor.com