Basin faucet
When buying a single-handle basin faucet, pay attention to the outlet diameter. Most of the products except TOTO's washbasin are on the market.
Most of GROHE's lavatory faucets are hard piped water, so you should pay attention to the height of the reserved water outlet, and the 35 fen downward from the basin is most suitable. When installing, be sure to choose a special angle valve for GROHE, and the angle valve must be fixed with the hot and cold water pipes of the wall outlet. When you find that there is a distance between the angle valve and the faucet hose, go to your purchase shop to purchase a special extension pipe for the Grohe faucet. Remember, do not use other pipes to connect, because if the water pressure is high, it is easy to fall off, leak, and cause losses to you. If the inlet pipe is longer than the outlet pipe, you can cut it off according to your needs. If the angle is not appropriate, you can bend it to your desired position. Remember: Do not talk hard and bend to 90 degrees or greater than 90 degrees.
When installing the basin to remove water, do not forget to purchase the faucet's small connector (short for the faucet).
Before you install, please do not forget to flush the water pipe buried in the wall in advance. The flushing time is preferably 10-15 minutes.
Shower, bath faucet (wall)
When you have purchased showers, bathtubs, wall taps, you can choose the appropriate height to bury the water pipe. The distance between hot and cold water pipes must reach 15 points. Before installation, you must not forget to flush the water pipe to avoid excessive water quality and damage the mixer. If the elbow between the faucet and the wall joint is too long, cut off part of the 4-way wire. Remember: The 6-point connection to the faucet does not seem to be disorderly.
Concealed shower, bath faucet
After purchasing a concealed faucet, the faucet's valve plug is usually embedded in the wall. Be sure to pay attention to the thickness of the bathroom wall before embedding. If the wall is too thin, the valve plug cannot be embedded. The plastic protective cover of the valve plug should not be easily removed when it is embedded so as not to damage the valve plug in cement and other miscellaneous services. In addition, when embedding the valve core, it should also pay attention to the direction of the valve core up and down, left and right, so as not to miss the valve core.
Thermostat
Before installing the thermostatic faucet, please check whether the water pipe is left hot and right cold. Remember not to connect the hot and cold water pipes to the wrong pipe to prevent the faucet from working properly.
Gas and solar water heaters cannot use thermostats because the water pressure is too low.
Do not forget to install the hot and cold water filter when installing the thermostat.
Shower
When you install the shower and bathtub mixer, don't forget the filter inside the shower pipe when installing the shower. When installing the shower, the water pressure must not be too high, generally 1 - 3 kilograms is best, and no more than 5 kilograms. If the water pressure is too high, the water flow restrictor in the tap valve core can also be opened to reduce the water pressure, and the water saving effect can also be achieved.
Routine maintenance
In the process of using the faucet, it is necessary to frequently maintain and clean the scale on the surface of the faucet and the water sand inside the faucet to protect the bright chrome plating layer on the faucet surface (GROHE special cleaning fluid, special cleaning cloth). Do not use a rough towel and cloth to wipe the faucet, so as not to scratch the chrome plated layer, and do not touch the faucet with acid-alkaline items to avoid damaging its brightness.
Hydropower renovation solar water heater cement bathroom leak
Putian Integrated Housing Co., Ltd. , http://www.zjprefabhouse.com