The worst problem with gas water heaters is the fact that natural gas water heaters cannot reach fire . So, why can't the natural gas water heater get on the fire ? Let's find out the specific reasons and solutions based on some unobtrusive phenomena.
Why Natural Gas Water Heaters Can't Beat Fire How Natural Gas Water Heaters Can't Fight?
1, power problems, the battery is too old.
What happens: Check that the AC power plug indicator is on. If it is off, it indicates a power problem.
Solution: Replace the battery with new one.
2, solenoid valve failure.
The phenomenon that appears: If you only hear the ignition sound when the ignition, there is no magnetic attraction of the solenoid valve, it may damage or aging the solenoid valve. If the solenoid valve ages, it can pick up and start when the fire starts, and it hits a fire, but then it turns off. It may also be that the gas pressure is too high or too low, and the water heater using the cylinder gas will cause the output pressure of the cylinder pressure relief valve to be too high or too low, causing the water heater not to catch fire. There may also be dirt on the solenoid valve. The solenoid valve cannot pass gas and the gas cannot come out so that it will not ignite. Before confirming the malfunction of the solenoid valve, it is necessary to confirm whether the igniter control circuit is normal or not. If there is a fault, the solenoid valve cannot be controlled to close.
Treatment methods: Check the exclusion method to determine the specific reasons. If the solenoid valve is aging, replace the solenoid valve. If gas pressure is a problem, replace the new gas bottle. If the gas valve has dirt, clean it. If the ignition control circuit, maintenance circuit problems.
3, electric igniter failure.
Phenomenon: No ignition noise and sparks.
Treatment method: Check whether the pulse igniter and the controller have a fault on one side, and replace or repair the faulty condition.
4, ignition porcelain needle or induction porcelain needle problem.
Phenomenon: No ignition noise and sparks.
Solution: Check if the ignition needle is misaligned or aged. Replace it or place the ignition pin correctly. If the induction porcelain needle is aged, the sensing ceramic needle can be polished and placed as long as the flame can fully burn the porcelain needle.
5, water pressure problems.
Phenomenon: There are ignition sounds and sparks that burn out soon.
Solution: Open the tap to check whether the water pressure is too small. If the water pressure is too small, only water peaks will be staggered.
6, water vapor linkage device failure.
Phenomenon: No ignition noise and sparks.
Solution: Check the water vapor valve lining membrane aging or damage, can not push the micro switch, then replace the water vapor valve or maintenance.
7. The air source is not open or the intake air filter is blocked.
Phenomenon: There is no ignition spark.
Treatment method: Open the air source and clean the intake filter.
8, gas does not match.
Phenomenon: There is ignition sound, no spark.
Treatment method: If the liquefied gas water heater is connected to natural gas, the liquefied gas water heater needs to be converted into a natural gas water heater before it can be used.
9. Valve seals are corroded by gas.
Phenomenon: There is no ignition spark.
Treatment methods: Replace parts.
10, exhaust pipe can not be exhausted.
Phenomenon: There is ignition sound and spark, but soon extinguish.
Treatment method: There is a blockage in the smoke pipe, clear the smoke pipe. If the smoke tube is too long, install it again correctly.
The above information on how to make the natural gas water heater not reach the fire is briefly introduced here, I hope to help you. For more information, please visit this website. Stay tuned.
Gas water heater water heater
Measuring Tape,Small Tape Measure,Custom Tape Measure,Personalized Tape Measure
SHANGQIU CHAOYUE MEASURING TOOLS CO., LTD , https://www.chaoyuetools.com