How to troubleshoot agricultural pumps

1, can not start. Check the electrical connector is solid connection, switch contact is tight. If open circuit or poor contact should be repaired. 2, can not absorb water. The reason is that there is air in the pump body or intake pipe. Remedy: First water pressure up, and then filled with water pump, and then boot. At the same time check the check valve is tight, piping, fittings leaks, such as found leakage, remove the joint at the joints coated with oil or paint, and tighten the screws. Check the pump shaft seal ring, such as serious wear and tear should be replaced with new pieces. 3, motor overheating. Check the wiring and the switch is shorted, check the impeller and the impeller cover, the motor stator and the rotor have no friction, promptly remove obstacles. 4, lack of traffic. This is because the head is too high, the pipeline is too long or the pipeline has a right-angle bend caused. Should adjust the head, shorten the pipe or change the curvature of the pipeline, but also must check and eliminate the clogging filter and pipeline.

Big Flowrate Hydraulic Diaphragm Metering Pump

* Integral relief valve to protect the pump against over pressure

* Design is according to API 675 standard

* It contains standards diaphragm protect design

* Diaphragm material: PTFE

* Hydraulic actuated Diaphragm Metering Pump, no leakage.

* The flow can be adjusted from 0-100% while it's running or stopped.

*With the design of inner changeable release safety valve and limited auto-compensation valve.

* Both manual control and digital control for 4-20mA is available.

* Double diaphragm design with diaphragm rupture alarm system.

* Double or triple pump heads is available.

Big Flowrate Hydraulic Diaphragm Metering Pump,Accurate Dosing Hydraulic Diaphragm Metering Pump,Big Flowrate Hydraulic Chemical Diaphragm Metering Pump,Small Flowrate Hydraulic Diaphragm Metering Pump

Zhejiang Ailipu Technology Co., LTD. , https://www.alipu.com

This entry was posted in on