[Asia Fluid Network News] Selection of deep well pump requirements: First, according to the caliper, the initial water quality pump. Different types of pumps have certain requirements on the hole diameter. The maximum size of the pump is less than 25 ~ 50mm of the hole diameter. If the borehole skew, the maximum size of the pump should be smaller. In short, the part of the pump body can not close to the inner wall of the well to prevent the pump from damaging the well due to vibrations of the pump. Second, according to the well water, selected deep well pump flow. Each well has an economically optimal volume of water that should flow at a rate equal to or less than the level at which the well water level drops to half the well depth. When the pumping capacity is greater than the machine water, it will cause the machine wall collapse and siltation, affecting the life of the well; if the pumping is too small, the benefits of the well can not be fully realized. So, the best way is to pump wells pumping test, with the wells may provide the largest amount of water for the selected well pump flow basis. Pump flow to the label number or label on the manual shall prevail. Third, according to the well water level decline and the water pipeline head loss. Determine the actually required head of the deep well pump, which is the head of the deep well pump, which equals the vertical distance (net head) from the water level to the surface of the sump with the loss lift. Lost head lift is usually 6 ~ 9% of the net head, usually 1 ~ 2m. Pump the lowest impeller into the water depth of 1 ~ 1.5m appropriate. The total length of the downhole portion of the pump tube shall not exceed the maximum length of the well into which it is specified in the pump instructions. Fourth, wells containing more than one ten thousandth of sediment wells, should not install the use of deep well pump. Because well water content is too large, such as more than 0.1%, will accelerate the wear of rubber bearings, causing pump vibration, shorten the pump life.
LED Grow panel include led grow light bar, Panel Grow Lamp, full spectrum led grow light works well for all plant growth, can replace sunshine light.
We can make red blue lighting and 4000k white lighting, many models panel grow light for you to choose.
Plant grow lamp is used in applications where there is no natural light or where supplementary light is required.
For example, in winter, when the possible hours of daylight may not be enough to achieve the desired plant growth.
Full Spectrum Panel,Panel Grow Lamp,Grow Light Bulb,Led Plant Light
Shenzhen Wenyi Lighting Technology Co., Ltd , https://www.wygrows.com